Question 1

How are plastic pipe and fitting joints made?

Accepted Answer

The Q&E (Quick & Easy) method is used, where a plastic ring is placed on the end of the pipe and then the pipe and ring are extended using a hand or battery tool. After the extension, the tube is inserted into the connector and immediately afterwards the tube and the ring contract around the nipple of the connector.

Question 2

What is needed for testing before I put the flexible pipe system into service?

Accepted Answer

A pressure test must be carried out before the pipeline is put into service.
The tightness of the PEX pipe system can be quickly verified by following the test procedure below:

Increase the pressure to 1.5 x max pressure (15 bar for service water pipes) and maintain the pressure at this level for half an hour.
Lower the pressure quickly to half the max pressure (5 bar).
Pressure rises and stabilizes
Pressure should remain constant for 1.5 hours

Question 3

What do I need to consider when installing the anchor bracket?

Accepted Answer

The anchor bracket acts as an anchor point for the second end of the PEX pipe
The anchor bracket can be attached to the frame structure or left in the casting
The installation of the hook and loop boxes on the shower is facilitated by the use of a mounting bracket or mounting plate to ensure the desired 150 mm installation clearance (the mounting plate also offers a product with a clearance of 80 mm)

Question 4

What do I need to to consider when installing a distribution cupboard?

Accepted Answer

The distribution closet can be installed either as a surface-mounted or flush-mounted installation. Pipe penetrations to the manifold cupboard are brought in with penetrant bolts. One of the manifold cabinet penetrations shall be reserved for leakage detection. Unused pipe outlets at the bottom of the manifold cupboard are plugged. When installed in a false ceiling, a perforated door shall be used to expose any leakage.

Quick and easy jointing technology for a flexible plastic pipe system

Plastic pipe fittings with Q&E technology

PE-Xa plastik borularla plastik bağlantı parçalarının yenilikçi birleştirme teknolojisi

Hızlı – Basit – Güvenli

Uponor Quick & Easy – Boruları saniyeler içinde birleştirerek zamandan ve montaj maliyetlerinden tasarruf sağlar

Bağlantı parçalarınızı PEX plastik borularla birlikte seçin

Quick & Easy plastik boru bağlantı parçalarının avantajları

Quick & Easy bağlantı parçasının avantajları

Musluk suyu bağlantıları için Quick & Easy sistemi

Kollektör kurulumu

Tüm sorularınızın cevapları

FAQs

PEX plastik borular için dokümanlar ve hizmetler

Esnek plastik boru sisteminin bileşenleri

Sorularınız mı var? Bizimle iletişime geçin.